Windows ME Setup

Make New Connection

Open Control Panel.

Double-click on the Dial-Up Networking icon.

Double-click on Make New Connection and follow the steps below.

Under the Name of the Computer you are Dialing, type ASIS and ensure that the modem currently installed on your computer is selected.

Click Next.

In this example it is 707-555-5555. You will not connect with this Number!
See our Number Finder to Find the Number you need to Dial.
Check with the Operator to make sure the Number you intend to Dial is a Toll Free Call!

In the Dial-Up Networking window, click the ASIS icon with your right mouse button and select Properties with your left mouse button.

Click Next then click Finish.

Setting up Dial-up Networking.

In the Dial-Up Networking window, click on the ASIS connection with your right mouse button and select Properties with your left mouse button.

You will see the following screen :

Place a check in the Use area code and Dialing Properties box.

If you are on a LAN (Local Area Network), you should consult with your Network Administrator before going any further, as changing the numbers in this section could result in the loss of your LAN connectivity.

Click the Networking tab.

The type of Dial-Up Server should be set to PPP: Internet, Windows 2000/NT, Windows ME

Ensure that the boxes next to Enable software compression and TCP/IP are checked. All the other boxes must be unchecked.

Click TCP/IP Settings

If you are connecting via a modem:

Enable Server Assigned IP Address.
Enable Server Assigned Name Server Addresses.

Primary and Secondary WINS remain as zero's.
Place a check next to Use IP header compression and Use default gateway on remote network.

Click OK and then click Security

Enter Your username in the username box.

Enter Your password in the password box.

Place a check in Connect Automatically

Click the Dialing tab.

If you want to select ASIS as your default Internet connection place a check next to: This is the default Internet connection.

Next place a dot in the radio button next to: Always dial my default connection.

You can also enable Dial-up Networking to disconnect if idle for the time specified.